I have been researching and waiting on a good time to start a kit for years. I am military and have been stationed overseas for the past 10 years so I have been waiting until I get back to the states. I am finally coming back to the states and as a result pulled trigger on a kit.
Here is a list of tools that I have for this project
Tools I currently have
- DDRT-2
- Pneumatic rivet squeezer I had planned to build a RV-14 but I'll still find ways to use this.
- CDI Torque wrenches These are the exact same as Snap On, they just dont have the name and cost about half.
- Fuji Mini-Mite 3 I am going to prime the interior and attempt to paint the exterior, fingers crossed.
- Safety wire pliers
- Countersink bit #30 120 degree
- Countersink bit #21 120 degree
- Unibit #3 1/4-3/4
- Hand rivet puller
- ATS Air Riveter
- Deburring tool
- Hand seamer
- Fluting pliers
- 3/32 silver clecos
- 1/8 copper clecos
- 5/32 black clecos
- 3/16 copper clecos
- cleco pliers
- Scotch bright wheel
- Hole debur tool
- Microstop countersink
- Scotch bright maroon pads
- double/bubble epoxy
- Astro pneumatic tool ADN14 rivet nut drill adapter
- Close quarter rivet pulling wedge
- Epoxy Primer
- Air Compressor
No comments:
Post a Comment